机床刀具钨钢合金回收

热线电话(微信同号)

15552518465

新闻资讯

News & Trends

联系我们

CONTACT US

名称:骏豪数控刀具

地址:济南市槐荫区营市西街

电话:15552518465(微信同号)

Q Q:547250371

邮箱:yangcunbo-1986@163.com

联系人:杨经理

钨钢铣刀回收的使用保养知识

发布时间:2021-04-04 09:39:27 来源:http://www.jnskdj.com 作者:骏豪 浏览量:

1、钨钢铣刀不用防锈油

1. Tungsten steel milling cutter does not need antirust oil

钨钢的主要成份是碳化钨钢(WC)与钴Co,不存在铁的成份,所以,只要不粘到切削液,是不会产生腐蚀的。

The main components of tungsten steel are tungsten carbide (WC) and cobalt Co. there is no iron component. Therefore, as long as it does not stick to the cutting fluid, corrosion will not occur.

2、用完需清洁整理

2. Clean after use

一般产品在加工的过程中,都会存在加工尺寸深度各方面的不同,所以,都会存在中途换刀的可能。中途换下来的刀,一般都会或多或少的粘上一些铁屑(也有可能是铜、铝屑,因加工工件不同),为了方便下次使用,尽量用气枪吹掉上面的铁屑。

General products in the process of processing, there will be different dimensions and depth of processing, so there will be the possibility of Midway tool change. Generally, some iron filings will be stuck on the knife that is changed in the middle of the way (it may also be copper and aluminum filings, due to different workpiece processing). In order to facilitate the next use, try to blow off the iron filings with an air gun.

3、清洁完后需放回包装盒

3. Put it back into the packing box after cleaning

钨钢(硬质合金)铣刀与白钢铣刀不同,材质硬度比较高,如果不小心碰到,或是掉地上,都有可能造成刃口的破损,很多时候,有缺口的刀就无法使用。建议刀具清洁完成后,尽量放回包装盒内,这样就能减少很多人为的损坏。

Tungsten steel (cemented carbide) milling cutter is different from white steel milling cutter. Its material hardness is relatively high. If it is accidentally touched or dropped on the ground, it may cause damage to the cutting edge. In many cases, the cutter with notch can not be used. It is suggested that the tool should be put back into the packing box as far as possible after cleaning, so as to reduce a lot of man-made damage.